News and Announcements
ARTICLE
某型机A 框右侧扇形摇臂支架装配的工艺技术改进方法及检测技术
旸 胥,
红宣 余,
帆 王
Show Less
1
中航西飞汉中航空零组件制造有限公司,
中航西飞汉中航空零组件制造有限公司
art 2023 , 2(1), 166–168;
Published: 20 January 2023
© 2023 by the Author(s). Licensee Art and Design, USA. This article is an open access article distributed under the terms and conditions of the Creative Commons Attribution -Noncommercial 4.0 International License (CC BY-NC 4.0) ( https://creativecommons.org/licenses/by-nc/4.0/ )
Abstract
某型机A框右侧扇形摇臂支架的装配,相对复杂,工艺尺寸要求高,在安装前期制扇形摇臂螺栓孔时定位基准选择难度大,因此该组件装配时需借助专用工装夹具制螺栓孔,但因两侧支架形状复杂,支架上斜筋与制螺栓装配孔产生干涉,实施难度大,钻头易跑偏,导致孔位不准确,配钻的支架与管子报废几率大。为保证零件的技术条件要求和操作者的可操作性,需对原始加工工艺方法进行改进,利用工装制造及计算检测,改进后的方法实践验证成功,其二者配钻达到一次交检合格率100%,实践验证成功。
Keywords
飞机扇形摇臂
工艺技术改进
检测技术
References
[1] 倪朝晖.液压支架柔性装配专用工装设计[D]. 宁夏大学,2022.DOI:10.27257/d.cnki.gnxhc.2022.000380.
[2] 李贺,郝平凯.液压支架结构件装配工艺及常见问题分析[J]. 山东工业技术,2019,(06):26.DOI:10.16640/j.cnki.37-1222/t.2019.06.021.